- What will a bush hog cut?
- How much horsepower do I need for a 5 foot bush hog?
- Can you bush hog in reverse?
- How much horsepower do I need for a 10 foot bush hog?
- What is the best bush hog on the market?
- What RPM should you bush hog at?
- How fast does a PTO spin?
- How much horsepower do you need for a 6 foot bush hog?
- How long does it take to bush hog 1 acre?
- Can you bush hog in the rain?
- How much should I charge to bush hog?
- How much horsepower do I need for a 7 foot bush hog?
What will a bush hog cut?
The following is a short list of a examples of the ways bush hogging can be used and benefit you:Clearing tall grass.Cutting saplings 1 inch or less in diameter.Maintaining overgrown back forty/pasture areas.Preparing land for property development.Clearing vines, weeds, brush, and other excessive plant growth.More items…•.
How much horsepower do I need for a 5 foot bush hog?
25 HPThe rule of thumb is 5 HP per foot of cutter. Thus a 5 foot bush hog requires 25 HP.
Can you bush hog in reverse?
Re: Bush hogging backwards? My advice is to remove the FEL (slopes and FEL are a bad combo), mow up the slope in reverse (wont hurt your brush hog as long as you don’t push it into the ground) and mow down the slope in forward, always keep the front of your tractor pointed downhill.
How much horsepower do I need for a 10 foot bush hog?
60 to 65 hpRe: Big enough tractor for 10 ft brushhog I’d say in MOST conditions, you’d want 60 to 65 hp at a minimum. Grass and weeds will put more pto load on the tractor than brush and saplings in most cases. But with a 10′ mounted mower, more critical than HP, you need a good heavy tractor.
What is the best bush hog on the market?
Top 8 Best Heavy Duty Brush Hog ReviewsSwisher WRC11524CL Predator 24 in. … Farmer Helper 41″ Heavy Duty Flail Mower Cat. … Billy Goat BC2600HEBH 26-Inc Outback Brush Mower, 13 HP Honda Engine, Electric Start.More items…•
What RPM should you bush hog at?
540 RPMRe: Correct PTO RPM to Bush Hog My bushhog manual says that it should be run at 540 RPM. I would definitely adjust the slip clutch. It’s rather easy.
How fast does a PTO spin?
540 rpmThe PTO and drive shaft rotate at 540 rpm (9 times/second) or 1,000 rpm (16.6 times/second) when operating at full recommended speed. At all speeds, they rotate in proportion to the speed of the tractor engine.
How much horsepower do you need for a 6 foot bush hog?
50 HP50 HP should be more an adequate for a 6 foot bush in my humble opinion. If I remember correctly, Bush Hog has specs on recommended HP for their various mowers. Don’t worry about the power needed to move it. That is pretty much inconsequential.
How long does it take to bush hog 1 acre?
If you’re bush hogging with a tractor, what size bush hog is it? If a 5 ft, charge around 30/hour, 10ft, 40-45/hour. If you have 200 acres, with a 10ft bush hog, you could finish in roughly 2-3 days (not sure how long you will work) if like a foot ball field and easy to cut.
Can you bush hog in the rain?
You can bush hog in wet grass but you may not get as good a cut and the trash may not clear as well from under the hog. It will take a lot more power to pull the BH in wet grass though. Cutting brush and other coarse material would not be an issue as I have done that with no problems when raining.
How much should I charge to bush hog?
For legit bush hogging jobs I usually charge around $100 an acre. For that much acreage I’d give a discount and be around $75-$80 an acre. You are definitely low-balling yourself. “Gros’ Lawn Service, Where It’s Never Good To Have An Overgrown Bush!”
How much horsepower do I need for a 7 foot bush hog?
Question about size of tractor needed to pull 7′ bush hog | TigerDroppings.com. Try about 50-60 hp if you plan on doing any work with it.